Part 4: Advanced LHP Modeling

This webinar explains how Thermal Desktop and FloCAD can be applied to simulate complex and transient phenomena in LHPs, including condenser design, start-up, thermostatic control, and gravity assist (evaporator below condenser). The design of an actual LHP will be used to demonstrate concepts; the implications of attaching large masses to the evaporators (cooled electronics and support structures) will become clear as a result.

This webinar is the final installment of a four-part webinar series on LHPs and approaches to modeling them. Each webinar will last 60 minutes and is designed to be attended in the order they were presented. If you miss one in the series, please check out our video page for a recording, or contact us before the next webinar starts.

Prerequisites: Familiarity with LHP modeling approaches in TD/FloCAD (see Part 1Part 2 and Part 3).

Sorry that you missed this webinar. You can watch a recording here.

dispersed vs. coalesced front

Tuesday, June 26, 2018, 1-2pm PT, 4-5pm ET

This webinar describes flat-front modeling, including where it is useful and how it works. A flat-front assumption is a specialized two-phase flow method that is particularly useful in the priming (filling or re-filling with liquid) of gas-filled or evacuated lines. It also finds use in simulating the gas purging of liquid-filled lines, and in modeling vertical large-diameter piping.

Prerequisites: It is helpful to have a background in two-phase flow, and to have some previous experience with FloCAD Pipes.

Register here for this webinar